Edelbrock Carburetor 1407 for Ford F150

About this part

Edelbrock carburetor, made to fit the 1987 Ford F150.

Condition: New. Part number 1407 from Edelbrock.

Note: Performer Series Carburetor; New; 4 bbl; 750cfm; Square Flange 4150; Manual Choke; Single Fuel Inlet Capability; Gasoline; Mechanical Secondary With Velocity Air Valve; Adpt. PN2696 Or Kit PN2697 Is Required~Adpt. PN2732 Must Be Used When Installing On Certain Intakes~Calibrated For Performance~Electric Choke PN1478 Can Be Added If Needed~For Use On Pre-Pollution Controlled Vehicles (PPCV) ~New Fuel Filter Between Fuel Pump And Carb Is Required~Not Calibrated Or Compatible With Alcohol / Race Or E-85 Pump Fuel~Not For Computer Controlled Vehicles~Proper Installation Is The Responsibility Of Installer; May Void Warranty~Universal Throttle Linkage Type; Satin Finish; Non-EGR Compatible

Features

• Change Jets/Adjust Floats/Replace Needles-Seats w/o Fuel Drain
• Installation And Tuning DVD Included With Every New Carb
• Factory Set Float Levels; Adjustments Are Rarely Needed
• Match With A Variety of Manifolds
• Made In The U.S.A.
• Dependable Street Performance/Smooth Throttle Response
• Designed/Calibrated For Optimum Street Performance
• Bolts On And Runs Right Out of The Box
• 2-Piece Design Means No Gaskets Below The Fuel Level
• Incl. Both Timed And Full Vacuum Ports For Ignition Advance

Check the fitment table for trim and engine before ordering. If your vehicle is not listed, contact us with your VIN and we will confirm the fit.