Edelbrock Carburetor 1406 for Ford F250

About this part

Edelbrock carburetor, made to fit the 1987 Ford F250.

Condition: New. Part number 1406 from Edelbrock.

Note: Performer Series Carburetor; New; 4 bbl.; 600cfm; Square Flange 4150; Electric Choke; Single Fuel Inlet Capability; Gasoline; Mechanical Secondary With Velocity Air Valve; Adpt. PN2732 Must Be Used When Installing On Certain Intakes~Calibrated For Fuel Economy~For Use On Pre-Pollution Controlled Vehicles (PPCV) ~New Fuel Filter Between Fuel Pump And Carb Is Required~Not Calibrated Or Compatible With Alcohol / Race Or E-85 Pump Fuel~Proper Installation Is The Responsibility Of Installer; May Void Warranty~Universal Throttle Linkage Type; Satin Finish; Non-EGR Compatible

Features

• Factory Set Float Levels; Adjustments Are Rarely Needed
• Made In The U.S.A.
• Dependable Street Performance/Smooth Throttle Response
• Not Recommended For Performer RPM or Torker II Manifolds
• Change Jets/Adjust Floats/Replace Needles-Seats w/o Fuel Drain
• 2-Piece Design Means No Gaskets Below The Fuel Level
• Incl. Both Timed And Full Vacuum Ports For Ignition Advance
• Bolts On And Runs Right Out of The Box
• Match With A Variety of Manifolds
• Installation And Tuning DVD Included With Every New Carb

Check the fitment table for trim and engine before ordering. If your vehicle is not listed, contact us with your VIN and we will confirm the fit.