Edelbrock Carburetor 1411 for Chevrolet Camaro

About this part

Edelbrock carburetor, made to fit the 1971 Chevrolet Camaro.

Condition: Remanufactured. Part number 1411 from Edelbrock.

Note: Performer Series Carburetor; Remanufactured; 4 bbl; 750cfm; Square Flange 4150; Electric Choke; Single Fuel Inlet Capability; Gasoline; Mechanical Secondary With Velocity Air Valve; Adpt. PN2696 Or Kit PN2697 Is Required~Adpt. PN2732 Must Be Used When Installing On Certain Intakes~For Use On Pre-Pollution Controlled Vehicles (PPCV) ~New Fuel Filter Between Fuel Pump And Carb Is Required~Not Calibrated Or Compatible With Alcohol / Race Or E-85 Pump Fuel~Not For Computer Controlled Vehicles~Proper Installation Is The Responsibility Of Installer; May Void Warranty~Universal Throttle Linkage Type; Satin Finish; Non-EGR Compatible

Features

• Match With A Variety of Manifolds
• Bolts On And Runs Right Out of The Box
• Incl. Both Timed And Full Vacuum Ports For Ignition Advance
• Installation And Tuning DVD Included With Every New Carb
• 2-Piece Design Means No Gaskets Below The Fuel Level
• Made In The U.S.A.
• Dependable Street Performance/Smooth Throttle Response
• Designed For Stock To Performer Lever Engines
• Change Jets/Adjust Floats/Replace Needles-Seats w/o Fuel Drain
• Factory Set Float Levels; Adjustments Are Rarely Needed

Check the fitment table for trim and engine before ordering. If your vehicle is not listed, contact us with your VIN and we will confirm the fit.