Climate Control
AC Receiver Drier
An AC receiver drier stores refrigerant and removes moisture and debris from the system. Our catalogue lists 60 AC receiver driers from $16 to $202 for 1985-2020 vehicles. GMC leads with the Sierra 1500, Sierra 2500 HD and Yukon, followed by Ford models such as the Explorer and F350 Super Duty.
Shop ac receiver drier by vehicle
AC Delco A/C Receiver Drier W0133-1898056 for Chevrolet Silverado 1500
Fits 2003 models
AC Delco A/C Receiver Drier W0133-1898056 for Chevrolet Silverado 1500
Fits 1999–2004 models
AC Delco A/C Receiver Drier W0133-1898056 for GMC Sierra 2500 HD
Fits 2001–2003 models
AC Delco A/C Receiver Drier W0133-1912198 for Chevrolet Silverado 1500
Fits 2003 models
Why the drier matters
The receiver drier sits on the high pressure side, usually near the condenser. A desiccant inside absorbs moisture, which would otherwise mix with refrigerant and form acids that damage the compressor and valves. A filter screen also catches debris.
The desiccant can only hold so much water. Once the system has been opened for any repair, the drier should be replaced. A clogged drier can cause poor cooling and frost at the drier outlet.
Choosing your drier
Most of our driers are new and made of aluminum. Some include gaskets and seals, and listings note whether a mounting bracket or service port is included.
Some vehicles have the drier built into the condenser, and you replace a cartridge or the whole condenser. Others use an accumulator on the low side instead. Check which design your vehicle uses. AC Delco makes many of the listings here, along with Metrix, Motorcraft, API and GPD.
Install timing
Fit the new drier last, right before you pull a vacuum. Keep the caps on until the moment you connect it, since the desiccant starts absorbing moisture from the air once it is open.
Use new O-rings at each fitting. Use the vehicle selector and read the fitment table for engine and rear air notes. Compare the old part number if two driers look the same.
AC Receiver Drier questions
How often should an AC receiver drier be replaced?
There is no set mileage. Replace it any time the system is opened for repair, such as a compressor, condenser or hose job.
What is the difference between a receiver drier and an accumulator?
Both hold desiccant. A receiver drier sits on the high side in systems with an expansion valve. An accumulator sits on the low side in systems with an orifice tube.
Can a bad receiver drier cause poor cooling?
Yes. A clogged drier restricts refrigerant flow and can cause warm air and frost at the drier outlet. Moisture that gets past a saturated drier can also freeze in the valve.