Edelbrock Carburetor 1405

About this part

Edelbrock carburetor, made to fit the 1967 Chevrolet Corvette and 1 other vehicle.

Condition: New. Part number 1405 from Edelbrock.

Note: Performer Series Carburetor; New; 4 bbl.; 600cfm; Square Flange 4150; Manual Choke; Single Fuel Inlet Capability; Gasoline; Mechanical Secondary With Velocity Air Valve; Adpt. PN2696 Or Kit PN2697 Is Required~Adpt. PN2732 Must Be Used When Installing On Certain Intakes~Electric Choke PN1478 Can Be Added If Needed~For Use On Pre-Pollution Controlled Vehicles (PPCV) ~New Fuel Filter Between Fuel Pump And Carb Is Required~Not Calibrated Or Compatible With Alcohol / Race Or E-85 Pump Fuel~Proper Installation Is The Responsibility Of Installer; May Void Warranty~Universal Throttle Linkage Type; Satin Finish; Non-EGR Compatible

Features

• Installation And Tuning DVD Included With Every New Carb
• 2-Piece Design Means No Gaskets Below The Fuel Level
• Made In The U.S.A.
• Match With A Variety of Manifolds
• Factory Set Float Levels; Adjustments Are Rarely Needed
• Designed/Calibrated For Optimum Street Performance
• Dependable Street Performance/Smooth Throttle Response
• Change Jets/Adjust Floats/Replace Needles-Seats w/o Fuel Drain
• Bolts On And Runs Right Out of The Box
• Incl. Both Timed And Full Vacuum Ports For Ignition Advance

Check the fitment table for trim and engine before ordering. If your vehicle is not listed, contact us with your VIN and we will confirm the fit.