Replacement Front Upper and Lower Control Arm Kit 498-128

Part number: 498-128
Position: Front Upper and Lower
Condition: New
Our SKU: 498-128

Add your vehicle above to check this part against it.

$350.95

In stock

Shipping options and cost shown at checkout
Returns accepted on unused parts, see our returns policy
Unsure about fit? Send your VIN before you order

Vehicle fitment

Year	Make	Model	Trim, body and engine
1965	Chevrolet	Impala	Base Wagon 4-Door, 4.1L 4097CC 250Cu. In. l6 GAS OHV Naturally Aspirated
1966	Chevrolet	Impala	Base Hardtop 4-Door, 6.5L 6489CC 396Cu. In. V8 GAS OHV Naturally Aspirated
1968	Chevrolet	Impala	Base, 7.0L 427Cu. In. V8 GAS Naturally Aspirated

Rows are what the manufacturer lists for this part. If your trim or engine is missing, contact us with your VIN before ordering.

About this part

Replacement control arm kit for the front upper and lower position, made to fit the 1965-1968 Chevrolet Impala.

Condition: New. Part number 498-128 from Replacement.

Note: NEW, TUBULAR UPPER & LOWER CONTROL ARMS FOR A BODY GM; 4 Piece Kit Includes Complete Set of Brand New Southwest Speed Tubular Left and Right, Upper and Lower Control Arms, with Ball Joints, Shafts, Bushings, Bumpers, and Inserts. Upper Shafts and Lower Bushings mount in stock locations & ball joints fit in stock spindles. The upper arms have caster built-in to the arms, which helps provide straight-line stability. This will also give better handling and less tire wear. Polyurethane inserts on the lower arms locate the coil springs correctly and helps isolate suspension noise. The inserts are made to accept the coil spring ends. They will rotate as well, which enables them to accept ends of springs, even if the springs have been taken out and re-positioned, or cut. The upper arms weigh approximately 9.6 lbs. each with everything installed and the lower arms weigh approximately 13 lbs. These arms are the perfect complement to any race car, hot rod, or restoration.

Check the fitment table for trim and engine before ordering. If your vehicle is not listed, contact us with your VIN and we will confirm the fit.