Edelbrock Carburetor 14063 for Chevrolet Camaro

About this part

Edelbrock carburetor, made to fit the 1978 Chevrolet Camaro.

Condition: New. Part number 14063 from Edelbrock.

Note: Performer Series Carburetor; New; 4 bbl.; 600cfm; Square Flange 4150; Electric Choke; Single Fuel Inlet Capability; Gasoline; Mechanical Secondary With Vel Air Valve; Adpt. PN2696 Or Kit PN2697 Is Required~Adpt. PN2732 Must Be Used When Installing On Certain Intakes~Calibrated For Fuel Economy~For Use On Pre-Pollution Controlled Vehicles (PPCV) ~New Fuel Filter Between Fuel Pump And Carb Is Required~Not Calibrated Or Compatible With Alcohol / Race Or E-85 Pump Fuel~Not For Computer Controlled Vehicles~Proper Installation Is The Responsibility Of Installer; May Void Warranty~Universal Throttle Linkage Type; Black Powdercoat; Non-EGR Compatible

Features

• Factory Set Float Levels; Adjustments Are Rarely Needed
• Made In The U.S.A.
• Dependable Street Performance/Smooth Throttle Response
• Not Recommended For Performer RPM or Torker II Manifolds
• Match With A Variety of Manifolds
• Installation And Tuning DVD Included With Every New Carb
• 2-Piece Design Means No Gaskets Below The Fuel Level
• Incl. Both Timed And Full Vacuum Ports For Ignition Advance
• Bolts On And Runs Right Out of The Box
• Change Jets/Adjust Floats/Replace Needles-Seats w/o Fuel Drain

Check the fitment table for trim and engine before ordering. If your vehicle is not listed, contact us with your VIN and we will confirm the fit.